-
Whole house water filter systems are placed on the main water line entering your home, and designed to remove rust, sediment, chlorine and other chemical contaminants from all water entering your home. So no matter where you are in your house, whether it’s the guest bedroom shower, outside hose, kitchen or bathroom sink, you and your family can have clean, healthy and great tasting water. Not only does a whole house water filter give you the luxury of clean great tasting water from every faucet in the house it can also help extend the life of appliances that use water, such as dishwashers, water heaters and washing machines, because it removes the sediment, chlorine and other contaminants that would otherwise be entering those appliances.
Specifications
- Actual Size: 9-3/4 inches (length) x 4-1/2 inches (outside diameter)
- Media: Activated Carbon Block
- Filter Life: 15,000 Gallons
- Micron: 10 Nominal
- Flow Rate: Up to 5 GPM
Designed to Fit
Fits most 10 x 4.5-inch filter housings
Contaminants Removed
- Chlorine Taste and Odor
- Dirt
- Sand
- Sediment
Comparable Part Numbers
- 155782-43
- PENTEK PM-BB
- PENTEK 155782-43
- 4EPM10-934
Easy Installation
- Turn off water supply. Press red pressure-relief button (if present).
- Unscrew housing. Remove large o-ring, wipe clean and set aside.
- Discard used filter cartridge. Wash housing with dish soap and warm water using a nonabrasive sponge or cloth. Rinse thoroughly. Fill 1/3 with water. Add about 1 tablespoon of bleach and scrub to disinfect. Rinse thoroughly.
- Lubricate o-ring with clean silicone grease. Change o-ring if any damage cuts or degradation are present. Insert o-ring in groove.
- Insert new filter cartridge.
- Screw housing onto the cap and hand-tighten. Do not over tighten. Make sure cap standpipe slips into cartridge.
- Turn on water supply. Press pressure-relief button (if present). Check for leaks before leaving installation.
Warranty | No |
---|